Formwork and flat brick plaster
gräfix 76 SES
Coating mortar for formwork and facing bricks
Grey coating mortar for interior and exterior use
The light coating mortar is used for the direct plastering of masonry formwork and facing bricks made of e.g. aerated concrete or polystyrene. gräfix 76 SES can also be used for levelling uneven areas and for levelling masonry joints. Not for plaster substrates! Plaster thickness: 6 to 10 mm
Yield: 22 litres of fresh mortar from a
25 kg bag with 7 litres of water
Delivery: 25 kg bag
- Grey standard plaster mortar according to DIN EN 998-1
- for wall formwork blocks, facing bricks, etc.
- for fabric levelling, e.g. as weather protection
- Compressive strength: CS III
- approx. 22 litres of fresh mortar
- approx. 880 litres/to
- Processing time approx. 1 hour (depending on weather conditions)
- Delivery in 25 kg paper bag
- 40 bags per pallet/1.0 tonne
- Ideal for wall formwork blocks made from polystyrene or facing bricks, for example
- Can be applied by hand or with a plastering machine
- Very good machinability thanks to processing-enhancing additives
- Indoors and outdoors
- Also ideal for fabric levelling
- For levelling uneven surfaces
- Remove unsound coatings
- Do not use on gypsum-based substrates
- Mix one bag of gräfix 76 SES with approx. 7 litres of water
- Stir well and stir again after 5 minutes
- embed gräfix 621 as reinforcing mesh
- Plaster thickness: approx. 6 to 10 mm
- Spray on gräfix 76 SES and spread with the butterfly
- Yield: with 6 mm plaster thickness approx. 147 m² per tonne, approx. 3.7 m²/bag
